Location

Vancouver, British Columbia — Silver Bull Resources, Inc. (TSX: SVB, NYSE MKT: SVBL) (“Silver Bull”) is pleased to announce another batch of drill results from the underground drill program twinning a series of “long holes” in a high grade silver zone situated at the eastern end of the Shallow Silver Zone on the Sierra Mojada Project in Coahuila, Northern Mexico.

Highlights from this batch of holes include:


  • High grade silver intercepts including: 42.65 meters @ 202.7g/t Ag (including 3.9m @ 878g/t Ag & 3.2m @ 325g/t Ag), 52.6 meters @ 144.4g/t Ag (including 2m @ 759g/t Ag & 3m @ 256g/t Ag), 50.45 meters @ 110.9g/t Ag (including 9m @ 260.2g/t Ag & 2m @ 333g/t Ag), and 15.25 meters @ 182.4g/t Ag (including 2.4m @ 360g/t Ag & 1.9m @ 311.2g/t Ag).

  • High grade zinc and lead intercepts including: 1.3 meters @ 14.85% Zn, 2 meters @ 11.3% Zn, 1.82 meters @ 15.25% Zn, and 11.2 meters @ 2.3% Pb.

  • Mineralization remains open in the north, south, east and westerly directions.
Silver Bull’s 3,000 meter drill program is ongoing with 2 underground “Termite” rigs twinning a series of long holes with up to 50 meter long BQ sized diamond core drill holes. The main target area is a high grade silver zone hosted along an east-west trending structure with a present traceable strike of approximately 3 kilometers. The purpose of the program is to increase confidence in a historical long hole data set which defines the high grade zone and represents just under 38,000 meters of drilling which was either severally restricted or discarded in Silver Bull’s latest NI43-101 resource report on the Shallow Silver Zone dated July 5, 2012.

In addition to confirming the grade and tenor of the silver mineralization with the twinning program, much of the historical long hole data set ended in significant mineralization, so the program will also look to extend the mineralization by drilling longer holes. Due to the limited range of the Termite drills, and despite extending some holes by as much as 25 meters, some holes still end in mineralization.

This recent drilling, coupled with historical channel sampling and our ongoing underground mapping program shows at least three distinct east-west trending structures which host high grade zones of silver mineralization. In places, these east-west trending structures are cross cut by a series of northeast trending faults resulting in a “blow out”, which yields a much wider zone of high grade silver mineralization. A halo of silver mineralization grading up to 80g/t exists in between the high grade fault zones and provides the tonnage for a potential “bulk minable” deposit in an open pit setting. The high grade silver zone remains open in all directions and sits above and slightly adjacent to a significant body of zinc mineralization which has a present strike length of 1.5 kilometers and an average grade >8% Zn.

A table of the reported long holes is shown below.










































































































































Drill StationHole IDTotal Depth (m)From (m)To (m)Interval (m)Ag (g/t)Zn (%)IncludesComment
Station 2T1201952.950.0049.1549.1530.6including 1.3m @ 149g/t Ag, 3.6m @ 101.74g/t Ag, 24.55m @ 2.16% Zn, 1.3m @ 14.85% Zn and 9.8m @ 1.44% Pb
Station 3T1202020.900.0018.4018.4015.5including 1.4m @ 55.6g/t Ag, 3.7m @ 5.22% Zn and 3.7m @ 0.91% Pb
Station 4T1202116.650.0015.2515.25182.44.5including 2.4m @ 360g/t Ag, 1.9m @ 311.29g/t Ag, 2m @ 11.3% Zn and 2.2m @ 8.81% Zn
Station 4T1202242.650.0042.6542.65202.72.4including 1.82m @ 15.25% Zn, 1.8m @ 12.72% Zn, 2.3m @ 465.22g/t Ag, 3.2m @ 325.72g/t Ag and 3.9m @ 878.01g/t Agended in mineralization
Station 4T12023not assayed – poor recovery
Station 4T1202454.200.0052.6052.60144.4including 3m @ 256.03g/t Ag, 2m @ 759g/t Ag and 4m @ 5.94% Zn
Station 4T1202550.450.0050.4550.45110.9including 2m @ 333g/t Ag, 9m @ 260.21g/t Ag and 6m @ 3.93% Znended in mineralization
Station 3T1202634.650.009.009.0059.2including 2.25m @ 127.27g/t Ag and 2.15m @ 1.96% Zn
Station 3T1202734.650.0029.0029.0035.6including 20m @ 1.88% Zn, 5m @ 90.39g/t Ag and 11.2m @ 2.3% Pb
Station 3T1202837.250.0029.8529.8520.2including 4.2m @ 61.44g/t Ag and 2m @ 4.61% Zn
Station 3T1202948.908.4538.3029.8580.3including 0.85m @ 156g/t Ag,3m @ 511.72g/t Ag and 5.55m @ 1.75% Zn
Station 3T1203044.100.0044.1044.1021.9including 2.15m @ 122.98g/t Ag and 2.05% Znended in mineralization
* Intervals shown are mineralized lengths of core and are not necessarily true widths.

Tim Barry, President, CEO and director of Silver Bull states, “We continue to be very pleased with the results from the long hole twinning program and we are gaining a good understanding of the mineralization in the system. Holes from Station 4 which is reported in this news release, as well as the previously reported Stations 1 and 2, show very high grade silver mineralization grading up to 912g/t silver over wide intervals and sit along a prominent east-west trending structure which hosts the high grade mineralization. Drill station 3 in contrast, sits off the main east-west trending structure but still remains in a mineralized rock package grading up to 80g/t silver and which will provide the bulk tonnage in between the high grade zones for an open pit type operation.”

About the Shallow Silver Zone: The “Shallow Silver Zone” is an oxide silver deposit (+/- zinc & lead), hosted along an east-west trending fracture-karst system set in a cretaceous limestone-dolomite sequence. At a 20g/t cutoff grade the Shallow Silver Zone has a measured resource of 3.023 million tonnes at an average grade of 65 g/t for 6.343 million contained troy ounces of silver, an indicated resource of 38.560 million tonnes at an average grade of 50 g/t for 61.694 million contained troy ounces of silver, and an inferred resource of 6.491 million tonnes at an average grade of 45 g/t for 9.478 million contained troy ounces of silver. The mineralized body averages between 30m — 90m thick, up to 200m wide and remains open in all directions. Approximately 60% of the current 3.8 kilometer strike length is at or near surface before dipping at around 6 degrees to the east.

Zinc Exploration Target: In addition to the silver resource, Sierra Mojada also contains a significant “zinc oxide exploration target” which sits directly below and adjacent to the Shallow Silver Zone at its eastern end. The “Red” and “White” zinc zones have been identified through historical data containing 3,733 channels and 1,045 long holes over a 1.5 km strike length, but has too few core drill holes to presently delineate a NI43-101 compliant mineral resource. The zinc mineralization is composed of hemimorphite and lesser smithsonite and forms a tabular body hosted mostly within the upper dolomite along the east-west trending Sierra Mojada fault. It is located 600 meters from a functioning railway and has been periodically mined for zinc grading >20% over the last 100 years.


Figure 1. Location of the long hole twinning program at the eastern end of the property. The entire Shallow Silver Zone as defined in the recent NI43-101 resource report dated July 5, 2012 completed by SRK Consulting (Canada) Inc. is shown in purple.


Figure 2. The locations of the first four underground drill stations in relation to mapped structures at the eastern end of the Shallow Silver Zone and historical long holes with mineralized intervals greater than 60g/t Ag. The high grade silver mineralization is hosted along east-west striking structures that are traceable for over 3 kilometers. (* refers to drill holes previously reported)

Sample Analysis and QA/QC: All samples have been analyzed at ALS Chemex in North Vancouver, BC, Canada. Samples are first tested with the “ME-ICP41m” procedure, which analyzes for 35 elements using a near total aqua regia digestion. Samples with silver values above 100ppm are re-analyzed using the Ag-GRA21 procedure, which is a fire assay with a gravimetric finish. Samples with zinc, lead, and copper values above 10,000ppm (1%) are re-analyzed using the AA46 procedure, which is a near total aqua regia digestion with an atomic absorption finish.

A rigorous procedure is in place regarding sample collection, chain of custody and data entry. Certified standards and blanks, as well as duplicate samples are routinely inserted into all sample shipments to ensure integrity of the assay process.

About Silver Bull: Silver Bull is a US registered mineral exploration company listed on both the NYSE MKT and TSX stock exchanges and based out of Vancouver, Canada. The flagship “Sierra Mojada” project is located 150 kilometers north of the city of Torreon in Coahuila, Mexico, and is highly prospective for silver and zinc. Silver Bull also has 2 mineral licenses in Gabon, Central Africa, which are prospective for gold, manganese, and iron ore.

The technical information of this news release has been reviewed and approved by Tim Barry, MAusIMM, a qualified person for the purposes of National Instrument 43-101.

On behalf of the Board of Directors

“Tim Barry”

Tim Barry, MAusIMM
Chief Executive Officer, President and Director

INVESTOR RELATIONS:
Matt Hallaran
+1 604 336 8096
[email protected]


Cautionary Note to U.S. Investors concerning estimates of Measured, Indicated and Inferred Resources: This press release uses the terms “measured resources”, “indicated resources”, and “inferred resources” which are defined in, and required to be disclosed by, NI 43-101. We advise U.S. investors that these terms are not recognized by the United States Securities and Exchange Commission (the “SEC”). The estimation of measured and indicated resources involves greater uncertainty as to their existence and economic feasibility than the estimation of proven and probable reserves. U.S. investors are cautioned not to assume that measured and indicated mineral resources will be converted into reserves. The estimation of inferred resources involves far greater uncertainty as to their existence and economic viability than the estimation of other categories of resources. U.S. investors are cautioned not to assume that estimates of inferred mineral resources exist, are economically minable, or will be upgraded into measured or indicated mineral resources. Under Canadian securities laws, estimates of inferred mineral resources may not form the basis of feasibility or other economic studies.

Disclosure of “contained ounces” in a resource is permitted disclosure under Canadian regulations, however the SEC normally only permits issuers to report mineralization that does not constitute “reserves” by SEC standards as in place tonnage and grade without reference to unit measures. Accordingly, the information contained in this press release may not be comparable to similar information made public by U.S. companies that are not subject NI 43-101.

Cautionary note regarding forward looking statements: This news release contains forward-looking statements regarding future events and Silver Bull’s future results that are subject to the safe harbors created under the U.S. Private Securities Litigation Reform Act of 1995, the Securities Act of 1933, as amended (the “Securities Act”), and the Securities Exchange Act of 1934, as amended (the “Exchange Act”), and applicable Canadian securities laws. Forward-looking statements include, among others, statements regarding measured, indicated and inferred resource estimates, the anticipated scope and targets of future drilling in the Shallow Silver Zone, the ability to increase the confidence of the long hole data set the ability to increase the resource and overall grade at the Sierra Mojada project and the ability to delineate a zinc resource in the zinc exploration target. These statements are based on current expectations, estimates, forecasts, and projections about Silver Bull’s exploration projects, the industry in which Silver Bull operates and the beliefs and assumptions of Silver Bull’s management. Words such as “expects,” “anticipates,” “targets,” “goals,” “projects,” “intends,” “plans,” “believes,” “seeks,” “estimates,” “continues,” “may,” variations of such words, and similar expressions and references to future periods, are intended to identify such forward-looking statements. Forward-looking statements are subject to a number of assumptions, risks and uncertainties, many of which are beyond our control, including such factors as the results of exploration activities and whether the results continue to support continued exploration activities, unexpected variations in ore grade, types and metallurgy, volatility and level of commodity prices, the availability of sufficient future financing, and other matters discussed under the caption “Risk Factors” in our Annual Report on Form 10-K for the fiscal year ended October 31, 2011 and our other periodic and current reports filed with the SEC and available onwww.sec.gov and with the Canadian securities commissions available on www.sedar.com. Readers are cautioned that forward-looking statements are not guarantees of future performance and that actual results or developments may differ materially from those expressed or implied in the forward-looking statements. Any forward-looking statement made by us in this release is based only on information currently available to us and speaks only as of the date on which it is made. We undertake no obligation to publicly update any forward-looking statement, whether written or oral, that may be made from time to time, whether as a result of new information, future developments or otherwise.

SHARE THIS POST?

Facebook
Twitter
LinkedIn
WhatsApp
Telegram
Email